例句與造句

1. The finite element method analysis and the practice indicated that the reinforced foundation section can use composite modulus to computer the settlement , and the settlement of the center of the old road must be analyzed under different conditions
   有限元分析及工程實踐表明，對于加固區可采用復合模量法來進行疏樁復合地基的沉降計算，而對于原路中心處應結合原路不同的工況合理選擇分析方法，使情況更加接近實際。
2. It shows that the calculation results derived from the rigid - pile stress divergence approach is more precise than that of national code approach ; and the national code approach is defective in calculating the composite modulus by attempted to use the theory and calculation method of rigid - pile composite foundation
   結果表明，采用剛性樁復合地基的應力擴散法比復合地基“規范法”預測變形精度更高；規范法計算復合模量的方法存在不足。
3. ( 3 ) based on the working performance and mutual influence of the system of pcc pile - soil - cushion , pcc pile composite foundation is discussed in elastic method . a new calculation method of composite modulus of the pcc pile composite foundation is developed . furthermore , pile - soil stress ratio and settlement can be derived from the proposed method in this paper
   ( 3 )基于pcc樁?土?墊層所組成的一個工作體系，綜合考慮各部分的工作特性及相互影響，對pcc樁進行整體分析，建立樁體平衡方程，考慮pcc樁在褥墊層及下臥層中的上、下刺入量對復合模量的影響，并通過迭代的方法最后確定樁體模量發揮系數，提出了一種求解pcc樁復合地基模量的計算方法，進而得到pcc樁復合地基的沉降計算和樁土應力比公式。
4. ( 4 ) according to the settlement calculation method in this paper , the main influence factors , such as displacement ratio , modulus of cushion , modulus of pile , and coefficient of subgrade , are discussed in this paper and the curves that reflect the relationships of the composite modulus and the influence factors have been achieved
   ( 4 )根據本文建立的沉降計算方法，對復合地基模量的主要影響因素：置換率、褥墊層彈模、樁體模量、基床系數等進行探討，最后得出了它們和復合地基模量之間的關系曲線。
5. It's difficult to find composite modulus in a sentence. 用composite modulus造句挺難的